With the ATOMOS CONNECT attached, you will be able to tap on Input to switch to SDI as your input. You will then be prompted to reboot your NINJA V+ so that it can to change to the SDI input. Tap Confirm and wait for your device to reboot in SDI source mode. Once in this mode, the input menu will resemble the image shown above.
The ATOMOS CONNECT features a connector for 12G SDI input, which allows you to monitor and record SDI video up to 4Kp60 from a range of professional cameras and video sources.
You can only switch from HDMI input to SDI input when the AtomX SDI Expansion Module or ATOMOS CONNECT is connected to your NINJA V+.
To use the ATOMOS CONNECT with your NINJA V+, firmware version 10.8 or later needs to be installed. To use SDI RAW, firmware version 10.6 or later needs to be installed.
To use the SDI RAW feature with ATOMOS CONNECT you will need to activate this feature. Refer to the Activating Codecs and Features section for more information.
Compatibility Mode (SDI)
Where SDI has been selected as your input, a Compatibility Mode toggle switch will be visible under Source. This mode improves the signal locking process over SDI, when working with specific cameras that use a slightly different version of the 12G standard. For more information refer to atomos.com/support
Comments
0 comments
Please sign in to leave a comment.