When an AtomX SDI Expansion module or ATOMOS CONNECT is attached to your NINJA V, you can cross convert signals between HDMI and SDI.
This means that where HDMI sources are connected to your NINJA V, an SDI signal can be output from both of the BNC connectors on your AtomX SDI Expansion Module. In this scenario, both BNC connectors on the module can be used for two simultaneous SDI outputs, which allows you to output the same signal to two monitors.
The SDI connector on ATOMOS CONNECT is an Input only, so HDMI signals connected to your NINJA V cannot be output via SDI with an ATOMOS CONNECT.
Where an SDI video signal is connected to your AtomX SDI Expansion module or ATOMOS CONNECT, you can output an HDMI signal over the HDMI Out connector on your NINJA V.
Whilst converting the signals listed above, you can use the Output Options in the Output menu to downscale and crop the signals. The HDR section provides options for outputting HDR versions of the signals after cross conversion. For more information refer to the VIDEO OUT section.
To use the cross conversion feature, firmware version 10.6 or later needs to be installed on your NINJA V. Once you have installed this firmware, cross conversion will happen automatically and does not need to be enabled.
Cross conversion of SDI RAW video inputs is possible, once your NINJA V has been activated for RAW at my.atomos.com. For more information refer to the You can add the SDI RAW feature to your NINJA V by purchasing the optional SDI RAW upgrade at my.atomos.com. section.