This page allows you to define a network role for each NINJA on the network as either Server or Client, so that Client units can connect to the timecode network created by the Server unit. It also allows you to add other devices like audio recorders to the network via Bluetooth. The settings that appear on this menu page will vary, depending on the network role of the NINJA V+. Some settings will only appear when your NINJA V+ is set to Server mode, whilst others will only appear when it is set to Client mode. See Network role below for more information.
The AirGlu RF - SYNC network menu may not display connected AirGlu devices when using the ATOMOS CONNECT, but the client devices will receive Timecode and display a SYNC Network ID.
Tap to cycle between the options to set the network role for the NINJA V+ as either Server or Client. The ‘Server’ unit will then provide the timecode source for all ‘Client’ units on the network. For any other NINJA that you want to sync with, ‘Client’ should be selected as the Network Role on it’s Sync Config page. This allows the Client units to connect to the timecode network created by the Server unit.
Once you have finished setting up your Server unit, tap Start Network to toggle the Sync network on and off. Note that on Client units you will have a Join Network switch instead of Start Network.
When this setting is ‘on’, the client unit will connect to the Sync Network created by the Server unit. Tap to toggle on and off.
Use the ‘-’ and ‘+’ to select an RF channel between 1-12. Changing the RF channel can help in situations where you are experiencing interference from other devices. Ensure that the RF channel on any Client units is set to the same RF channel as the Server unit.
When this setting is enabled, tapping record on the Server Unit NINJA V+ will cause any other NINJA V+ or GoPro on the network to start recording as well.
On Client units, Network FPS will be displayed and the frame rate will match the frame rate of the server unit.
Provides information on the signal strength.
Provides information on the Network.
Tap to cycle through the options until you find your region and tap ‘confirm’ to accept the new region or ‘cancel’.
Press the Set Timecode button to open the Sync Network Timecode page.
Tap to cycle through ‘Time of Day’, ‘Manual’ and ‘Input’. Select ‘INPUT’ and tap ‘Set Timecode’. TBC
Set Device Name
Tap to change the name of your NINJA V+ unit. For more information refer to Unit Name in the Date & Time section.
You can pair with up to six Bluetooth devices, like an iPhone or a Zoom F6 audio recorder, so that they can connect to the timecode network. By connecting an ATOMOS Ultra Sync Blue to the timecode network, you can pair it with Bluetooth devices that are much further away from the AtomX SYNC module. For more information, see atomos.com/accessories
AirGlu Bluetooth is currently not enabled when using ATOMOS CONNECT, and devices cannot be paired to receive Bluetooth.
Follow the manufacturers instructions for each device to set it up for Bluetooth pairing, then Tap Pair to connect to the device. Once paired, the device will be listed in the The Sync Network menu page displays all of the devices that you have added to the timecode network. The columns in the table will list the details for each connected device in the sync network. page, along with the other connected NINJA V+’s and other devices. For information on pairing with an iOS device or Mac computer for use with the AtomRemote app, refer to the Installing the AtomRemote app section.
Tap to unpair all devices that are connected to the timecode network.
Free Pairs Available
The numerical figure indicates the number of Free Pairs that are available for Bluetooth pairing.
For connected Client units, the timecode source should be set to AtomX Sync on the Timecode page when using the AtomX SYNC Module or AirGlu when using the ATOMOS CONNECT module.
Multiple NINJA units can be added to the timecode network. Simply repeat this process on each unit.